This type of banner stand does a
neat job of supporting different sizes of banners. This system can be 24
or 32 inches wide and any height
up to 78 inches with its standard hardware components.

The crossbars can attach to the vertical pole at any point allowing
for any height size for the banner.
On the upper and lower edge of the graphic (vertical) banner there is a Velcro® strip. Corresponding Velcro strip is on the crossbars. The banner simply "velcros" onto the crossbars.

This banner system is an elegant design with engineering that results
in a sleek, easy to use stand.

This is a type of banner stand display system that is solid and stable, versitile and very well made.

A number of banner stands are available for displays and exhibiting, but only the Chrono Expo 2 creates the illusion that the graphic panel or mural stands on its own. More than
a typical banner stand, the Chrono
is a unique graphic support system!

The vertical tension support rod assembles in sections. Depending upon how many sections of the rod you connect, the Chrono is easily assembled for different lengths or height. The width is determined by the cross bars. Configure the Chrono in many different sizes and shapes.

The secret is the superbly engineered support bar at top and bottom that grips the graphic panel with ten hex-driven set screws. Only a narrow lip of the support bar is visible in front. The vertical "spine" of the system consists of a series of tapered rods that fit so well together they form a single tapered rod.

Self-contained, the graphic banner
is safely stored, ready for use, in the base of the banner stand.

The feet simply swivel out to stabalize the base.

The vertical pole is simply inserted into its depression in the base, and then you just simply pull the banner up like a window shade.

It's that simple.